Expert Answers about Four Winds
- Replacement Vent Cover for a 2001 Four Winds Majestic Flyer Motorhome
- If you are talking about a roof vent cover to help keep the rain out then I recommend going with the MaxxAir Standard RV and Trailer Roof Vent Cover # MA00-933066 because it is a universal application and mounts to the frame of your trailer roof vent.
For a replacement lid you will simply need to note what kind of hinge your roof vent uses. For a continuous hinge I recommend the Ventline # BV0554-01, for a 3-point hinge I recommend the Ventmate #CAM40153, and for a 4-point hinge I recommend...
view full answer... - Troubleshooting Integrated Brake Controller Not Identifying Boat Trailer with EOH Brakes
- It sounds as if you have electric over hydraulic brakes on your trailer, typically the factory Integrated Brake Controller (IBC) is not compatible with this system.
If your trailer has drum brakes the Hydra-Star Electric Over Hydraulic Actuator for Drum Brakes # HBA-10 is compatible with your IBC.
If your trailer has disc brakes the Hydra-Star # HBA16 will be compatible with your IBC on your 2014 Ram Pickup.
It is important to note that even though these EOH actuators are compatible...
view full answer... - Recommended Hitch for Class C Motorhome
- Which hitch you'll need for your Class C motorhome just depends on what the distance between the two frame stanchions that run lengthwise on the coach are; we don't have specific information for individual models, so you will need to measure the distance between those two parts of the frame.
The Curt # C13701 you were looking at is designed for Box frame, C-Channel frame, or I-Beam frames that are no more than 51" apart, and has a 2" drop to make it a bit easier to install a ball mount,...
view full answer... - How Long is Screw that Comes with Rubber Bumper # 37211745
- The screw that comes with the Rubber Bumper # 37211745 that you referenced is 1-1/4 inches long.
view full answer... - Recommended Anti-Sway And Steering Stabilization On Workhorse W20 Chassis Motorhome
- For your 2010 Fourwinds Serrano with Workhorse W20 Chassis, I have the sway bars and steering stabilizer you are looking for.
For the front anti-sway, I recommend the Blue Ox TigerTrak Front Axle Stabilizer # TT2304. This will minimize side-to-side movement to improve the overall stability. It will reduce body roll and diminish the effects of crosswinds and shifting cargo.
These are all confirmed to fit your 2010 Fourwinds Serrano motorhome.
view full answer... - How To Add a 7-Way to a 2008 Four Winds 5000 Motorhome
- I do have an option for you but there is not going to be an entirely plug and play 4 to 7-way adapter for your 2008 Four Winds 5000 Motorhome on a Ford E-450 Cutaway Chassis. In order to install a 7-way you will need the 7-Way RV and 4-Way Flat Adapter part # ETBC7. This adapter will plug into the 4-way you have now but you will need to run the brake output wire from this to the back of your brake controller and ground the adapter at the very least. In order to reach the back of the brake...
view full answer... - Replacement AC Unit for Dometic Duo-Therm Air Conditioner 630516.331 on 2008 Four Wind Siesta
- To replace the AC unit on your 2008 Four Wind Siesta Dometic Duo-Therm Air Conditioner 630516.331 I recommend picking up a Furrion Chill HE unit as they are the most efficient on the market. For a direct connect setup you need one of the following:
- White # FR42PV
- Black # FR32PV
These come with the direct connection wiring adapter for an easy installation as well as a start capacitor to help limit the amount of power needed to start the AC unit.
view full answer... - Best RV AC Unit Replacement for RVP 8000 Series Coleman Unit
- The RVP 8000 series A/C model is effectively a Coleman Mach air conditioner which means we have exactly what you are looking for with the Furrion Chill HE Replacement RV Air Conditioner for Coleman Setup # FR42PV. This is designed to replace Coleman units so it will install easily using same wiring and will allow you to use your current controls as well.
view full answer... - Will Greystone Microwave with Trim Kit # 324-000105 Work Well to Replace 900 Watt Microwave
- Yes, the Greystone Built-in Microwave with Trim Kit # 324-000105 matches your old microwave specs really well so it would work really great for a replacement. The wattage is the same, the voltage is the same, and the Hz is the same.
view full answer... - How to Determine if the Rubber Window Edge Weather Strip for RVs Will Fit My RV's Windows
- Unfortunately, I do not know. Weather stripping like the Rubber Window Edge Weather Strip for RVs # SR66ZR is not something that is standard and therefore we do not know what you have given your RV information.
Your best course of action is to compare it to what you currently have. For instance the Rubber Window Edge Weather Strip for RVs # SR66ZR you asked about is a press-in style that measures 1/4" wide x 1/2" tall and has a curve to it. If you are replacing the weather stripping around...
view full answer... - Recommended Replacement Interior Lights For A 2007 Four Winds Dutchman Kodiak Motorhome
- I took a look at your 2007 Four Winds Dutchman Kodiak Motorhome, and while I wasn't able to find out exactly what lights you have, I was able to locate a few similar lights for you to check out.
First, take a look at the:
-Omega RV Double Dome Light with Switch # 328-001-902XPW.
This light is not self-sticking, and will use screws to secure to the roof, however this light measures 11-/38" long, 4-3/4" wide, 1-3/4" deep and is compatible with 12VDC systems. Take a look at the installation...
view full answer... - How To Drain Hot Water Tank In RV
- We do not have a video on our website, but I'd be more than glad to walk you through it. It's just three simple steps:
Step 1. Turn off your water heater, LP gas and water pump. If you are connected to the city water supply, disconnect that as well.
Step 2. Run the hot water inside the RV until the water turns cold. This is to make sure the water heater is at a safe working temperature. Then go outside your RV and open the panel to the water heater.
Step 3. Open the pressure valve on...
view full answer... - Recommended Mate for Might Cord # A10-50FDT Female 50 AMP Detachable Twist Lock Connector
- A great connector that is compatible with the # A10-50FDT you were looking at is the Epicord 50 Amp Twist Lock Power Inlet part # 277-000140.
The one mentioned in the video just changed part numbers because it is now available in black # A10-50INBKVP and white # A10-50INVP.
A great cover for the # A10-50FDT to protect it from the elements is the # A10-50ACV.
I have linked all the above mentioned products to this page for your viewing and purchasing convenience.
view full answer... - Will Adco Class C RV Storage Cover 290-36042 Fit 2004 Four Winds Chateau 31Z
- RV roof covers like the Adco # 290-36042 for Class Cs like your 32-1/2-foot 2004 Four Winds Chateau 31Z are made to fit a range of RV lengths but they do not take into account any added height from accessory items like wheel ramps. The cover will certainly fit and secure properly to the RV since it works on RVs up to 36-feet in length but it is possible that the anchor straps will not reach down to the ramps.
It is possible you will need additional tie-downs like # EM04418 to secure the...
view full answer... - Steering Stabilizer and Sway Bar Recommendation for 2010 Four Winds Hurricane Motorhome
- The pricing for the Roadmaster steering stabilizers for your 2010 Four Winds Hurricane is interesting. We can only recommend the part # RM-RBK22-RSSA for your RV but depending on how the pricing is it might make the most sense to just order the bracket and stabilizer separate from each other with the part # RM-RSSA and # RM-RBK22.
The biggest improvement you'll make will be with a rear sway bar with the front sway bar being the next biggest improvement. So for that you'd want the # RM-1139-146...
view full answer... - Amber Light Bar About 16 Inches Long for Trailer Clearance Light
- We don't have an amber colored light that's exactly like the # MCL78RB you referenced. The closest I have is the Peterson Mini Identification Trailer Light Bar item # 427800, which measures 16-5/8" long and mounts on 16-1/8" centers. Note that this is also an incandescent light, not LED.
view full answer... - Recommended Black Solera Slide Out Awnings For An 86 And 117 Flange To Flange Measurement
- For a 117" measurement you would need the Solera RV Slide-Out Awning # LCV000182037 to get the black fabric. For the 86" measurement you would need part # Solera RV Slide-Out Awning # LCV000168106. I recommend picking up some butyl tape # AL28FJ to prevent water from leaking into the walls of your trailer through the mounting screws.
view full answer... - Can The Olefin HD RV Cover Handle High California Temperatures
- The Adco Olefin HD All-Climate + Wind RV Cover for Class A Motorhome # AD64ZR is designed for use in all climates so you should have no issues with your 125 degree weather in California. Of the materials on the market the Olefin is your best option in protection for your 2008 Four Winds Hurricane Motorhome.
I do want to note that this cover is designed for motorhomes up to 34' in length so you'll want to measure your motorhome before making your purchase to ensure you're ordering the...
view full answer... - Replacement Wireless Camera System for a Mandalay Motorhome
- Yes, the Voyager WiSight 2.0 Wireless RV Backup Camera System # ASA84YR would be an excellent option for a Mandalay Motorhome. The Voyager WiSigh is wireless which means there will be no wires running from the monitor to the camera. The monitor simply plugs into the cigarette lighter port and the camera has two wires, one for ground and one for power. If you already have an existing camera system you can just use the power and ground from this which makes for a very simple and easy install....
view full answer... - Where Is The Brake Controller Adapter Port Located on 2007 Hurricane Class A Motorhome
- Since your 2007 Hurricane Class A motorhome is built on a Ford F-53 chassis the port is under/behind the dash like you can see in the attached picture. The part # 3035-P that you referenced is the correct harness to use with a Tekonsha controller like the # 90885.
view full answer...
Go To Results